How To Tile Bathroom Floor
This line will match the line marked on the shower base floor.
How to tile bathroom floor. Repeat this until all of the gaps on the floor are covered. This simple step can save a. How to tile bathroom floor diy guide for laying tile. Once i had the old tile removed i had to do a little bit of structural work to repair some subfloor damage due to water and termites cutting out old rotten areas and replacing with.
Attaching an underlayment of cement board to sub flooring provides a level and sturdy surface to which bathroom tile can be easily attached. This bathroom happened to have an old pink tile floor with a thick mortar bed under it so removing it was a bit of a challenge. Call 1 877 go lowes or visit https low es 2c1mabh to learn more about installation services. Make sure you do not use the.
To tile bathroom floordon t leave the cleanup until the last if you are tiling an area greater than ten squire feet. Use the tile cutter to cut the tile. Lay the two parts of the cut tile back into shower base and mark out where they. If you plan to tile the wall leave a small gap between the wall and the tile on the floor.
Use a pencil to mark the spot where you need to drill. Firmly press the tile into the. Using your spirit level and pencil mark the line where it will need to be cut. Place some tape on the centre mark to prevent the drill.
Take your first tile and line it up so that it s flush with the edge of the shower base and follows the pattern of the bathroom tiles. Using a circular saw cut panels to fit measured bathroom and use a jigsaw to cut holes as needed to accommodate the toilet and other bathroom fixtures. Cut the waterproof membrane into lengths of the bathroom walls. I used a combination of a sledgehammer a hammer drill and a shovel to pry it up.
Place the tile in the cutter and run the blade along the line. Lay the membrane down so that half is on the wall and the other half on the bathroom floor covering the crack. Use a bucket of clean water and a soft sponge to work the grout on the tile surface gently. Mix up a small batch of thin set mortar and spread a thin layer on the cement board with the notched trowel.
The excess grout on the tiles will harden if you give it too much time. If you are not 100 confident installing flooring lowe s recommends that you hire a professional. Set the first tile in the far corner of the room and work towards the doorway. To stick the membrane down use either a paint roller or brush to paint over it with the waterproofing agent.
Lay several pieces of tile with tile spacers to establish even grout lines.